Battery And Recharge; Low Battery Signal; Charging The System - Nolangroup n-com ESS III User Instructions

5.

BATTERY AND RECHARGE

5.1.

Low battery signal

During its operation, the system provides the user with an alert when the battery is low (the LED lights
start to flash signalling "reserve"). From the first alert, the system has one hour of user time. A
warning is given every 10 minutes.
5.2.

Charging the system

Fig. 7
The charge will take place as follows:
When the ESS III system is connected to the battery charger, the LED lights flash about every 10
seconds. When the battery is charged, the ESS III system switches off.
N.B.: In case you are not planning on using the N-Com system for a long time, you need to fully
recharge the device before storing it away.
N.B.: In case the device is not used for a long time, carry out a complete recharging cycle of the device
at least once every 6 months to avoid possible damage to the battery.
N.B.: In case the N-Com system is left for more than 6 months without ever being recharged, the
device may not switch on; in this case, recharge the N-Com system for at least 24 hours (even if the
signalling LED is not flashing), then try to switch on the device again.
To charge the system, connect the system to a charger or
USB plug using the USB-C cable supplied.
9