GE GTW680 Owner's Manual & Installation Instructions page 18

Before you call for service...Troubleshooting Tips
Save time and money! Review the charts on the following pages, or visit GEAppliances.ca. You may not need to call for service.
WATER
Small amount of water
remaining in dispenser
(Not all features are on
all models) at end of cycle
Short spray and delay
after pushing the Start
button
Water level seems low
Low water flow
Water siphoning out
of washer
Too many suds
Water leaks
Water temperature
seems incorrect
Water pumped out
before cycle is complete
Water won't drain
Washer spins and pauses
at the beginning of cycles
Possible Causes
Normal dispenser
operation
Lid was opened and closed
between cycle selection
and start
This is normal
Water valve screens are
stopped up
Drain standpipe is too
low or hose too far into
standpipe
Soft water
Too much detergent
Type of detergent
Type of detergent
Using too much detergent
in washer
Fill hoses or drain hose is
improperly connected
Household drain clogged
Drain hose rubs on wall
Constant water pressure to
fill hoses at water source
Cooler water temperatures
provide improved energy
efficiency
Water supply is turned off
or improperly connected
Water valve screens are
stopped up
Cool/Cold Water when
selecting Hot
House water heater is not
set properly
Lid lifted or cycle was put
in pause for over 24 hours
Drain hose is kinked or
improperly connected
This is normal
What To Do
START-UP SEQUENCE
Installation Instructions
Safety Instructions
he
he
NOTE: H C