H-P Products Vroom24 Installation

Vroom24 Cabinet Installation
1.
Locate cardboard
template inside
the cabinet.
2.
Place mounting
bracket in tem-
plate.
Secure with 5
screws as
shown.
3.
Remove the
cardboard
Template.
4.
Install the side
panels. Flex them
so the edges tuck
under the 6 plastic
molded tabs.
If you require additional information on installation, please visit: www.VroomYourRoom.com
H-P Products, Inc. 512 W. Gorgas Street, Louisville, OH 44641
5.
Attach accessory
brackets as
shown.
6.
Install the Vroom
in the mounting
bracket by push-
ing it into place as
shown. It will
snap in place
when installed
correctly.
7.
Connect the
vacuum tubing to
the Vroom's
connector on the
back as shown.
Do NOT glue,
press fit only.
8.
Connect the low
voltage wires on
the back of the
unit.
06-11 IH-109