Advertisement
AV Component Hookup
With an HDMI cable you can send both audio and video with a single cable,
making connecting simple and keeping wires neat.
If you have an HDMI-compatible TV and players, you can connect them
to the AV receiver with HDMI cables. Digital audio signals received
at HDMI IN input are output by the speakers and headphones connected
to the AV receiver.
HDMI
Cable/satellite
OUT
Connecting a supplied UP-A1 with the Port connector
TV
VIDEO 1
IN
Make a connection with the MONITOR OUT V when you watch videos on the TV.
HDMI
IN
HDMI
DVD/BD player
OUT
Coaxial feed from
TV antenna
If you are not using
Cable/satellite box,
Antenna input
please refer to the
(e.g., RF IN)
instruction manual.
IF NO HDMI
TV
DIGITAL
AUDIO
VIDEO
OUT
OUT
COAXIAL
L
R
COAXIAL
DIGITAL
OUT
Assigning the Digital Input
If there's no sound, you'll need to assign the
digital inputs as necessary using the setup
menus on the AV receiver's display.
If you connect your DVD player to the AV
receiver's DIGITAL IN COAXIAL 1, and your
cable/satellite receiver to the DIGITAL IN
COAXIAL 2, as shown, it's not necessary to
assign the digital input.
See the other side of this sheet for the Speaker hookup.
If your TV or player doesn't support HDMI, use the analog or digital
connections shown below.
DVD
OUT
player
Please ensure the monitor input
(VIDEO 1, VIDEO 2, VIDEO 3, etc.)
selected corresponds to actual
connection used.
L
Cable/
R
satellite
VIDEO
AUDIO
Antenna input
OUT
OUT
(e.g..RF IN)
On the front panel
TV
VIDEO 1
IN
Coaxial feed from
TV antenna
If you are not using
Cable/satellite box,
please refer to the
instruction manual.
Advertisement
