Charging The Battery - Ricoh WG-M2 Operating Manual

Charging the battery

Connect the supplied power adapter (D-PA164) to the camera
and charge the battery before using the camera for the first time
or if you have not used it for a long time.
2
1
While the camera is turned off, connect the USB
cable to the camera's USB terminal and the
power adapter.
2
Plug the power adapter into the power outlet to
start charging.
The power lamp blinks while charging.
When charging is finished, the power lamp turns off.
u Caution
• Do not use the supplied power adapter (D-PA164) for any
other purpose than that of connecting to this camera and
charging the designated battery. Doing otherwise may cause
a connected device to be damaged or overheated.
14
• The battery has reached the end of its service life when it
starts to run down soon after being charged. Replace it with a
new battery.
• If the power lamp does not light even if the camera is
connected to a power outlet, the battery is faulty. Replace it
with a new battery.
t Memo
• Charging time is a maximum of about 130 minutes (this may
vary depending on ambient temperature and charging
conditions). Charge the battery in a range from 0°C to 40°C
(32°F to 104°F).
• Battery performance may deteriorate as temperature
decreases. When using the camera in cold regions, we
recommend carrying a spare battery in your pocket to keep it
warm. Battery performance will recover when the
temperature returns to normal.
• Be sure to take a spare battery with you when traveling
abroad or to a cold region, or if you intend to take a lot of
pictures.