Compaq LP8000-F1 User Manual page 67

Table 6-1
Drive Parameters
continued
Parameter
NodeTimeOut = n
QueueDepth = n
QueueTarget = n
RATOV = n
ReadCheck = n
ResetFF = n
ResetTPRLO = n
RetryInterval = n
RetryloTimeOut = n
Description
Values are in seconds from 1– 255.
Default = 10. Controls the time-out at which a formerly
logged-in node will issue SELECTION_TIMEOUT error status
to an I/O request.
Values from 1– 64 (decimal). Default = 64. Requests per
LUN/Target (see Queue Target parameter).
Vaules 0 or 1 (decimal). Default = 0. 0 = QueueDepth applies
on a per LUN basis: 1 = QueueDepth applies on a Target
basis.
Values are in seconds from 2 to 120. Default = 2. This value
is the ELS request time-out.
Values 0 or 1. Default = 1. 0 = do not enable byte counting
for read operations. 1 = enable byte counting. If bytes
counted are less than requested transfer count, issue
underrun.
Values 0 or 1. Default = 1. 0 = ResetBus translates to LIP
(F7). 1 = ResetBus translates to LIP (FF). Used for WolfPack to
force reservations to be freed when ResetBus issued. Only
meaningful for FC_AL topology and Seagate native FC hard
drives.
Values 0 or 1. Default = 1. 0 = RestBus translates to LIP ( ). 1
= ResetBus translates to ThirdPartyProcessLogout + LIP ( ).
Used for WolfPack to force reservations to be freed when
ResetBus is issued.
Values are in seconds from 2-255. Default = 45. Used for
time-out interval if RetryloTimeOut = 1. Must be shorter than
Class driver TimeOutInterval.
Vaules 0 or 1. Default = 1. 1 = lets an HBA to time-out I/O
prior to port driver's time-out which causes a LIP/Link Reset.
Using the LPUTILNT Utility/NT 6-9
continued