5. Run iso9660:[utility]lp8ldr.exe – d dkd400 – p 2
Where – d = CD-ROM Device (at the SRM prompt type " show dev" to
display the value for your systems CD-ROM)
-p = the PCI bus number where the HBAs are located. If you choose to
download the firmware, all HBAs on the PCI bus specified by the – P
parameter will be programmed with the version of firmware contained
in the LP8ldr.exe file.
For AS8200 systems with HBAs installed on multiple PCI busses, it is
necessary to run the LP8ldr Utility once for each PCI bus that has an
HBA to be upgraded. Therefore if your system has two HBAs the utility
will be run twice. The – P parameter must be set to the new PCI bus
number each time the utility is run.
Firmware and Diagnostic Utility 5-9