Safety Information - Gearmore GCF41 Operation & Service Manual

Hammer knife flail mower shredder
Table of Contents

Advertisement

SAFETY INFORMATION

OPERATIONAL SAFETY:
Guards and safety shields are for your
protection. DO NOT operate equipment
unless they are in place.
Always operate tractor PTO (power-take-off)
at recommended RPM (revolutions per
minute).
Disengage tractor PTO and shift into neutral
before attempting to start engine.
Read and observe all safety decals on the
tractor and mower.
NEVER allow anyone within 25' of
machine while it is in operation.
DO NOT stop or start suddenly when
going uphill or downhill. Avoid operation
on steep slopes.
Be alert for holes in terrain and other hidden
hazards. Always drive slowly over rough
ground.
Reduce speed on slopes and in sharp turns
to prevent tipping or loss of control. Be
careful when changing direction on slopes.
Stop mower and tractor immediately upon
striking an obstruction. Turn off engine,
inspect mower and repair any damage before
resuming operation.
Disengage power to mower and stop engine
before dismounting from tractor, before
making any repairs or adjustments,
transporting or unclogging mower.
Take all possible precautions when leaving
tractor unattended: Disengage PTO, lower
mower, shift into neutral, set parking brake,
stop engine and remove key from ignition.
Front tractor weights or front tire ballast
should be used to enhance front end
stability on small tractors.
Check to make sur PTO is properly
connected and that the driveline is correct
to prevent bottoming out or pulling apart
during the full lift range of the hitch.
This implement is designed for a one-man
operation. It is the responsibility of the
tractor operator to see that no one is in the
proximity of the implement when it is
started. DO NOT operate the implement
with another person within 25' of the
implement.
NEVER operate mower with hatch in the
wrong working position.
NEVER run mower with rotorshaft out of
balance.
Page 2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gcf45Gcf53Gcf61Gcf69Gcf79

Table of Contents