Programming Dvd Player/Vcr Combo Control - One for All URC-6131 User Manual

IMPK6VR manual 1.0 2/21/03 5:46 PM Page 10
PROGRAMMING DEVICE CONTROL
(continued)
6. Repeat steps 1 through 5 (on the previous
page) for each device you want to control.
For future reference,write down each
working device code in the following boxes:
Code:
TV
Code:
PVR
Code:
DVD
Code:
CBL/SAT
Code:
AUD
Code:
VCR
PROGRAMMING DVD PLAYER/VCR
COMBO CONTROL
1. Turn on the DVD Player/VCR Combo and
insert a DVD.
NOTE: Please read steps 2 through 4 completely
before proceeding. Highlight or write down the
codes and device you wish to program before
starting step 2.
2. On the remote control, press
press and hold
blinks twice, then release
3. Use the Setup Codes For DVD Player/VCR
Combos (on page 21) to locate the brand
name and then enter the first four-digit
code for your device. If performed
correctly, the
NOTE: If the LED did not blink twice, repeat steps
2 through 4 and enter the same code again.
4. Aim the remote control at the device and
press once. It should turn off. If it
POWER
does not, repeat steps 2 through 4, trying
each code for your brand until you find one
that works. If it still does not work, try
Searching For Your Code on the next page.
NOTE: If the device does not have a POWER
key, press the
. Next,
DVD
until the (red light)
SET LED
.
SET
LED will blink twice.
(Play) key.
10