Trumpf TruConvert DC 1030 Operator's Manual page 82

Using the Reset button to
reset the IP address
Changing network settings
(IP subnet and gateway)
76
Operation
4. Press "Submit network settings".
The network settings are transferred to the device.
5. To restart the system control: press "Reboot".
If the IP address of the device was changed and is not known,
the IP address can be reset to the factory settings with the help
of the Reset button.
Notice: This function can also be used to reset all customer
parameters to the factory settings.
1 Opening for reset button
Reset button on the system control
6. Insert a small pen tip or piece of wire into the opening for
the Reset button and press the Reset button.
− Press for 3-5 seconds: IP address is reset to the factory
settings.
− Press and hold for 10 seconds: all device parameters
are reset to factory settings.
After the reset, the operating panel automatically performs a
restart.
7. In the sidebar, click on "Settings"
8. In the "Network" area, enter new values.
Input field Value
"Host address" Text field
"DHCP client" OFF
ON
"IP address" 192.168.1.3
(example)
"Subnet mask" 255.255.255.128
(example)
Input fields for network settings
.
Description
The device can be given an indi-
vidual name. This name instead of
the IP address can be entered in
the web browser in order to
access the device.
The device receives a fixed IP
address. The IP address is
entered in the "IP address" input
field.
The DHCP client is enabled and
receives an IP address from the
customer DHCP server.
The IP address is used to inte-
grate the device in a network.
The IP address can be entered in
the web browser in order to
access the device.
Set the same subnet mask as that
on the higher-level system control.
2022-06-22 A67-0147-00.BKen-0
Fig. 52
Tab. 27
01-01