Natural Gas
Conversion
3. Connect the bellows with natural gas orifice by
screwing clockwise tightly using the wrench.
Then connect and tighten the natural gas orifice
with inlet tube using the wrench.
Natural gas orifice is painted with a black mark.
Hardware Used
Wrench
4. Connect the natural gas hose with gas valve by
screwing clockwise tightly using the torque wrench.
Hardware Used
Torque Wrench
Requires a CSA Certified NG Conversion
kit 50 000 BTUs and 3/8" NG Hose.
supply piping system.
Page 10
3
inlet tube
NG air hole cover
bellows
4
natural gas hose
5
gas valve
natural gas supply
piping system