Download Print this page
One for All URC-1030 Reference Manual
One for All URC-1030 Reference Manual

One for All URC-1030 Reference Manual

Universal tv remote

Advertisement

Quick Links

Overview:
"Universal TV Remote"
1
Thank you for purchasing the
One For All
remote control. Before you can
Device
use your new remote control,
you will need to program it.
To do this, you need to tell the
remote control what TV set
you wish to operate. This is
Red Light
(LED)
done by following these easy
steps.
Mute
Power
Key
Key
Step 1:
Setup
Key
Install two (2) new AAA
Channel
batteries.
& Volume
Keys
Step 2:
Find the code for your
TV on the reverse side of
these instructions.
Step 3:
Enter the code.
Step 4:
Use your remote.
Step 1:
Installing the Batteries
®
1 Device universal
Your One For All
®
two (2) new AAA alkaline batteries.
To install the batteries:
On the back of
1
the One For All
1 Device , unscrew
and push down on
the tab and lift the
cover off.
Match the
2
batteries to the +
and - marks inside
the battery case,
then insert the
batteries.
Press the battery
3
cover back into
place and replace
the screw.
Test the unit by
4
pressing POWER.
POWER
The red light
should blink.
Even if your batteries die, the One For
All
®
1 Device built in memory back-up
will save your programmed setup
codes. The One For All
also retain the memory for another 10
minutes once you have removed the
batteries to replace them.
Step 2:
Looking Up Your TV Code
1 Device needs
1
Look at your TV to find
the brand name and write
it in the space below:
®
_____________________
2
Find your TV
Set-Up Codes
brand on the
RCA
3124
reverse side
Sony
1111
of these
instructions. The most
popular codes are listed first.
Write your codes here:
You will need one of these codes
to program your One For All
®
1 Device will
Device remote control.
Step 3:
Setting Up Your TV
1
Turn on your TV.
Press and hold SETUP until the One For All
2
blinks twice. Release SETUP.
SETUP
Using the example
3
shown on the right,
enter the first four-digit
code you wrote down.
(See "Looking Up Your
TV Code".) If you put
in the code correctly,
the red light will blink
twice.
4
Aim the One For All
Your TV should turn off. If it doesn't, repeat Steps 2-4, trying
each code listed for your brand until you find the one that operates
POWER
your TV.
®
1
®
1 Device's red light
How to Enter Codes
If your TV Press
code is:
3
3
CH +
1
1
VOL
2
VOL
2
4
CH _
4
®
1 Device at your TV and press POWER.

Advertisement

loading

Summary of Contents for One for All URC-1030

  • Page 1 Step 3: Setting Up Your TV Turn on your TV. Press and hold SETUP until the One For All ® 1 Device's red light blinks twice. Release SETUP. SETUP How to Enter Codes...
  • Page 2 Troubleshooting Admiral Aiko If you cannot get the One For All ® 1 Device Akai Alaron to operate your TV: America Action Anam Audiovox Try all of the codes listed for the brand of your TV in the Set-Up Codes section.

This manual is also suitable for:

One for all 1030