Advertisement
Quick Links
Essential 12V Battery Optimiser
For charging most 12 Volt batteries 4 - 30Ah
P. 2 - 7
2
see page 51 for foreign descriptions
1
Ventilation
2
Battery connection/
polarity error
3
Dead battery indicator
Oximiser 601 v.1
USER MANUAL
1
3
4
6
LED charge voltage indicator
4
Continuous fl oat charge
5
6
Induction cooling vent
www.oxprod.com
Advertisement
Related Manuals for Oxford Oximiser 601
Summary of Contents for Oxford Oximiser 601
- Page 1 For charging most 12 Volt batteries 4 - 30Ah P. 2 - 7 USER MANUAL see page 51 for foreign descriptions LED charge voltage indicator Ventilation Continuous fl oat charge Battery connection/ polarity error Induction cooling vent Dead battery indicator www.oxprod.com Oximiser 601 v.1...
-
Page 2: Important Safety Instructions
*SAVE THESE INSTRUCTIONS* (A) INTRODUCTION The OXIMISER 601 is a modern charger designed to charge, optimise and prolong the life of a 12-volt automotive battery. This OXIMISER 601 uses a continuous yet reducing charge current to ensure that the battery is charged correctly. -
Page 3: Polarity Test
If the battery is permanently damaged or will not accept a charge current, or if the voltage is below 3 volts, the Oximiser 601 will not attempt to re-charge. The red LED (<3V) light will light up to prompt you to disconnect the Oximiser 601 from the battery. 3. RECOVER: a. - Page 4 6. Do not operate charger with damaged cord or plug – replace the cord or plug immediately. If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed person in order to avoid a hazard. Oxford Products are unable to offer a repair facility.
- Page 5 Do not operate charger in a closed-in area or restrict ventilation in any way. A suitable location should be selected for the Oximiser 601. This should be away from any moisture and with suffi cient ventilation to allow for cooling and battery gas discharge.
- Page 6 Oximiser 601 when required. The leads provided are supplied with a weatherproof cap to help to ensure that the connections do not become corroded.
- Page 7 fi rst connecting the connection leads to the battery. - If the mains power to the Oximiser 601 is turned on but the battery is not connected to the charger, no power will be produced by this charger.