Bourgault 7000 Series Quick Reference Manual page 6

www.bourgault.com
5. Extra Weigh Scale Settings
a. If there is a question of the performance
of the weigh scales with erratic Weight
Difference alarms some extra filtering
settings can be verified in the Scale
Links.
b. These settings apply to each channel so
you have to highlight each channel on
the main page to check settings specific
to each channel.
c. On the UT app press
the Cycle Screen button
then press the DAN button
d. Enter the DAN numbers listed below
and confirm the values.
e. If a value needs to change use the up/
down arrows to change the digit. Use
the over arrows to switch which digit
you are adjusting. Alternatively you
can press on the DAN window and type
a value.
f. Press Enter once set. Even if you don't
change the value press the Enter button
to save it before entering a new DAN.
DAN
g. Model specific settings
DAN # 9000 Series Air Cart
3006 99
3007 99
3008 1
h. Repeat for all other channels.
P/N 0256-80-12
Assy P/N 0256-80-13
Weigh Scales - Quick Reference Guide
6. Angle Compensation
a. The Scale Link ECU has built in angle
b. DAN 1009 should be set to ACCEL to
c. The angle compensation filtering value
d. The orientation of the Scale Link ECU
e. The Scale Link ECU can be leveled by
f. Repeat these steps to confirm the angle
Enter
7000 Series Air Cart
30
10
4000
(v. 5.02 revised Jan 2023 )
compensation that is turned on to
correct the weight for the affect of hill
angles.
apply the compensation. This setting
is set individually for each channel by
having that channel highlighted before
entering the DAN number.
DAN 3308 should be set to 30.
DAN 3309 should be set to Front as the
direction facing forward on the unit.
using DAN 3304 and changing to select
Yes when asked to level the unit.
compensation is configured for the Tank
5 Scale Link ECU if equipped.
PITCH
ANGLE
ROLL
ANGLE
6
Page