Velocity RZA500.2 Instruction Manual

Features
Features
•
Full Range Class D
•
Balanced Differential Input Stage
•
Selectable Input Sensitivity
•
DC Detect Remote Turn-On Mode
•
Variable 12db Crossovers
•
Bridgeable
•
Large Gauge Speaker Output Terminals
•
Full Chassis Heat Sink
•
Specifications
650 Watts Peak Power
•
2 x 275 Watts @ 2 Ohm RMS
•
2 x 150 Watts @ 4 Ohm RMS
•
1 x 550 Watts @ 4 Ohm RMS
•
Frequency Response 20hz - 25khz
•
Crossover High/Low Pass 40hz - 400hz
•
@ 12db
Signal Input Range .41V - 10V Balanced
•
High & Low Level
RCA Input - Yes
•
Speaker Level Input - Yes (over RCA
•
connection)
Efficiency 87% @ Full Power
•
Remote Trigger 12V or Signal Sense
•
2 Channel Amplifier
Instruction Manual
Installation
Plan your amplifier mounting location and wire
routing in the bike. You will need to secure the
amplifier in a location that is not directly exposed
to water. The RZA 500.2 amplifier is designed
for humidity and extreme outdoor temperatures
but is not designed for submersion in water.
The inside structure of a Harley fairing is not
waterproof. The fairing is designed to channel
water away from the electronics inside the
fairing. Take this into consideration when deciding
on an amplifier mounting location.
Power Connections
8 Gauge cables should be used and run directly to
the battery terminals. Never ground the amplifier
to the frame or any other chassis ground point.
Always fuse the amplifier within 18 inches of
the battery with a 30 amp fuse and a fuse holder
that is designed for automotive/motorcycle
conditions. The fuse holder should be easily
accessible without the need for any special tools.
Never place the fuse holder in an area that will
not be accessible in an emergency.
Be sure that all power connections are secured
in a way that will not allow them to pull or vibrate
loose. Be sure that there is no exposed wire at any
of the connection points.
RZA500.2