Option Card Installation - Epson Equity I User Manual

3. Grip the card firmly by the top corners and position it as shown. The
contact pins should be pointing down and the components should be
facing toward the inside of the main unit.
4. Slide the card into the slot as shown in Figure 5-4, placing the tab at
the bottom of the retaining bracket into the corresponding notch at
the back of the computer.
Once the connector pins are sitting in the connector slot, push firmly
5.
(but carefully) to fully insert the card. If the connector does not seem
to be going in smoothly, do not force it; pull it all the way out and try
again, being sure to keep it straight.
Secure the retaining bracket to the frame of the computer with the
6.
small screw and washer. Long option cards are held in position at the
free end by the piece of foam inside the top of the lid of the main unit.
When you have finished installing the card, keep the packing in case
7.
you need to remove the card.
34
Figure 5-4. Option card installation