Related Manuals for BAFANG H610
Summary of Contents for BAFANG H610
-
Page 1: Table Of Contents
6 DEALER MANUAL FOR H610 (RM G070.250/350/500.D) CONTENT 6.1 Introduction 6.3 Drive Unit Installation 6.2 Specifications 6.3.1 List of Tools to be used 6.2.1 Outline and geometric size 6.3.2 Motor Installation 6.4 Maintenance 6.2.2 Surface 6.2.3 Storage Information BF-DM-C-RM G070-D-EN February 2023... -
Page 2: Introduction
6.1 INTRODUCTION • Scope Applies only to electrically powered pedelecs developed or licensed by Bafang. It is suitable for bikes, which have been developed for the city road, off road on gravel or sand use. The engine is not suitable for sport competitions. -
Page 3: Specifications
6.2 SPECIFICATIONS Motor model: RM G070.250.D / RM G070.350.D / RM G070.500.D Rated power (W) 250 / 350 / 500 Rated voltage (V) 36 / 43 / 48 Waterproof IP65 Certification CE-EMC Outdoor Temperatures -20℃~45℃ 6.2.1 Outline and geometric size OLD: 137mm Shaft length: 195mm Motor cable length: L=250mm... -
Page 4: Drive Unit Installation
6.3 DRIVE UNIT INSTALLATION 6.3.1 List of Tools to be used Use of the Tools Tools To fasten M12 flange nuts Open-end wrench To fasten the M5*8 screws on disk brake Internal hexagonal wrench 6.3.2 Motor Installation First place the disc brake on to non-cable Place a 4mm washer onto the cable-side side of the motor and tighten with six shaft first, then mount two stop pins onto... - Page 5 Mount two 2mm washers on both sides of Mount two end sheathes on both sides of the frame. shaft. Fasten two M12 flange nuts with open-end wrench at both ends of the motor. Torque requirement: 47-60N.m. BF-DM-C-RM G070-D-EN February 2023...
-
Page 6: Maintenance
6.4 MAINTENANCE • Maintenance must be carried out by autho- rized personnel with the correct equipment. • Do not disassemble the motor. • Do not use thinners or other solvents to clean the components. Such substances can damage the surfaces. •...