Page 2
Figure 1 Thermal Pad Placement on Silver Heat Sink .............. 3 Figure 2 Assembling the FCB-EV7520 in the Enclosure Bottom ..........4 Figure 3 Installing the Enclosure Top .................. 5 Figure 4 Fully Assembled Z3Cam-HD ................... 6 ___________________________________________________________________________________________ Z3 Technology, LLC ♦ 100 N 8...
Page 3
DOC-USR-0119-01 1.0 OVERVIEW If you will be providing your own Sony FCB-EV7520 or equivalent HD camera block for a full Z3Cam-HD unit, you have received a partially assembled system and will need to complete final assembly per the following instructions.
Page 4
Please consult Z3 Technology about connecting different devices BEFORE attempting it. (3) Connect the other end of the KEL ribbon cable to the PCB. WARNING: ONLY USE THE CORRECT KEL RIBBON CABLE PROVIDED BY Z3 TECHNOLOGY. Using an incorrect cable can permanently damage the camera body.
Page 5
(2) Use eight M2 x 3 mm finishing screws to attach the enclosure top to the enclosure bottom. Figure 3 Installing the Enclosure Top ___________________________________________________________________________________________ Z3 Technology, LLC ♦ 100 N 8 ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702...
Page 6
Z3Cam-HD Camera Installation Instructions DOC-USR-0119-01 Figure 4 Fully Assembled Z3Cam-HD (3) If desired, attach four rubber feet to the bottom of the enclosure. ___________________________________________________________________________________________ Z3 Technology, LLC ♦ 100 N 8 ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702...
Need help?
Do you have a question about the Z3Cam-HD and is the answer not in the manual?
Questions and answers