Related Manuals for Ozone WHITE 10000
Summary of Contents for Ozone WHITE 10000
- Page 1 Read the instructions carefully before using this device WHITE 10000 (FG-K) COMMERCIAL OZONE GENERATOR USER MANUAL Read the instructions carefully before using this device...
- Page 2 WARNING This air unit is not a medical device. Do not stop or modify any treatment or medication programs without consulting your doctor. Excessive ozone concentrations can irritate the mucous membranes or the respiratory tract. CAUTION DANGER OF INJURY BY ELECTRIC...
-
Page 3: What Is Ozone
WHAT IS OZONE? Ozone (O3) is a toxic gas with a typical odour, which is a normal component of the Earth’s atmosphere. Ozone is deliberately manufactured for various industrial purposes; it is produced naturally from oxygen by ultraviolet radiation, electric discharge, e.g. -
Page 4: Technical Specification
TECHNICAL SPECIFICATION Model: WHITE 10000 (FG-K) Input voltage: AC 220-240V/50-60Hz Energy consumption: 93 W Timer: 120 minutes Air volume: Maximum 125 CFM (3.5 M3/min.) Active oxygenation: 10,000 mg/h Noise level: 45 dB Dimensions: 350 x 260 x 170 mm Weight:... - Page 5 2 hours. HOLD function: When switched to the HOLD position, the device produces ozone indefinitely until you turn it off. (see “Application” on page 6 for recommendations) Operation switch and indicator: I lluminated if the device is operating (producing ozone).
- Page 6 (front view detail) Fuse: A replaceable fuse (3A) is located beside the power supply. Power supply: P ower supply connector, 220V-240V.
-
Page 7: Follow These Steps
When using the HOLD function, we recommend using the device with a remote-controlled socket so that you do not enter the room while the device is still working) Ozone very strong oxidizing effects , and at higher... - Page 8 ● There are no cracks in the plates, and each plate is aligned with the rear part of the unit. ● It is important that the ozone generator is properly earthed, in order to prevent injury by electric current. ● The fuse is installed correctly, and in a good condition.
-
Page 9: Maintenance
MAINTENANCE If the device has not been producing a sufficient amount of ozone for a longer period, then it is not efficient enough and the ozone plates must be replaced. They are normally changed after 5,000 hours of operation. Caution: You should not try to remove the unit cover, because there are no parts which the user could repair themselves. - Page 11 Read the instructions carefully before using this device WHITE 10000 (FG-K) COMMERCIAL OZONE GENERATOR USER MANUAL Read the instructions carefully before using this device Version 20/05/2020...
Need help?
Do you have a question about the WHITE 10000 and is the answer not in the manual?
Questions and answers