Epson PowerLite X9 User Manual page 60

note
You can adjust the
Progressive setting for
component video only when
480i/576i/1080i signals are
being input.
Fine-Tuning the Projector
60
■
Tracking
Adjust this value to eliminate vertical stripes in computer
images.
■
Sync
Adjust this value if computer images appear blurry or flicker.
■
Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Select this setting and use the arrow
buttons to center it.
■
Progressive
For composite video, S-video, and component video. Turn
this setting on to convert interlaced signals into progressive
signals (best for moving images). Leave the setting
images.
■ Input Signal
If the colors don't look right on the
setting for the type of equipment you've connected to the
Computer (Component Video)
computer or RGB-video connection, or
device that outputs a component video signal (with
connectors labeled Y/Cb/Cr or Y/Pb/Pr).
(composite or S-video signals only)
■ Video Signal
Select the setting for the type of equipment you've connected
to the port. Leave this setting at
Video
using a 60-Hz PAL system (then select
■
Aspect
Sets the image's aspect ratio (ratio of width to height). See
page 47 for more information.
for still
Off
setting, select the
Auto
port. Choose for a
RGB
for a video
Auto
unless you are
Auto
).
PAL60