Advertisement

Sunbeam Luna
EN
Installation manual
Fibre cement
February 2023 | Version 1.0 | This is the English translation of the original Dutch installation manual
supporting sustainability

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Luna and is the answer not in the manual?

Questions and answers

Summary of Contents for Sunbeam Luna

  • Page 1 Sunbeam Luna Installation manual Fibre cement February 2023 | Version 1.0 | This is the English translation of the original Dutch installation manual supporting sustainability...
  • Page 2: Safety Instructions

    General Description of the user This document is intended for the installer. Sunbeam Luna should only be installed by a trained installer who has fully read and understood the contents of this manual. Intended use and reasonably foreseeable misuse This type of Sunbeam Luna is suitable for installation on all pitched roofs featuring fibre cement and bitumen corrugated sheets. Sunbeam Luna must only be used according to the instructions in this document.
  • Page 3: Recommended Tools

    Preparation Recommended tools Socket bit 5/16" or 8 mm Electric screwdriver Chalk line reel Chalk Tape measure Socket bit 3/8" or 10 mm Marking the installation area 1. Using a tension line or chalk line, mark the outer contours of the field. 2.
  • Page 4: System Installation

    Fibre Cement system installation Extending mounting profiles (optional) Installing the mounting profiles COMMENT In some cases, the field may be larger than the mounting profile. This means the mounting profile must be extended. 1. Slightly loosen the screw that is being used to assemble the roof sheet.
  • Page 5 3. Place an end clamp into the end of each mounting profile, near the marked outer contours of the field. COMMENT All clamps in the Luna system are 12. Place a mid clamp in the mounting profiles, and slide the mid inserted clockwise into the mounting profile and removed counter- clamps against the first row of panels.
  • Page 6: Safety Standards

    The national regulations in the country of installation must be observed at all times. Make sure you are aware of the safety measures prescribed by Sunbeam or the country of installation. If in doubt, consult your safety officer. Ensure safety or health hazards are shared with the employer, supervisor and executive worker for their information.

Table of Contents