Advertisement
Setup
FOR FIRMWARE VERSION 2.0+
Up to 2 Extenders can be used in 1 ACR OLAS tracking system. Each Extender must first be connected to the Core/Guardian.
Each Extender will extend the range by 10 meters (25ft) in the same direction that the Extender is located.
Where to locate your Extender
1.
With your Core/Guardian in their permanent location walk
towards the area where the connection is normally broken
between an ACR OLAS transmitter and the Core/Guardian.
2.
The button on the Extenders will illuminate solid red when
Extender connection has been broken.
5.
Walk back towards the Core/Guardian until the red light
starts flashing and then continue for around 2 meters.
6.
Find a location within this area to securely hold the Extender.
If being used as a permanent solution the Extender should
Multiple Extenders
the connection between the Core/Guardian and the Extender
is broken.
3.
The Core/Guardian will beep 5 seconds on 5 seconds o to
indicate that the Extender connection has been lost.
4.
The ACR OLAS mobile app will alert to indicate that the
be connected to a 5V USB power supply.
7.
Walk around your vessel with your ACR OLAS transmitter to
ensure all areas are now within range.
Disconnecting an Extender for use with a different ACR
2s
OLAS receiver
1.
Press the control switch on the Extender for 4
seconds. The red light on the switch will illuminate for
2 seconds before switching o .
2.
The Extender can now be removed from the system.
3.
Any ACR OLAS transmitters that were being tracked
will need to be back within range of the
Core/Guardian to prevent the MOB alarm from being
triggered.
1.
The Core/Guardian will beep 5 seconds on 5 seconds o
www.acrolas.com
Advertisement
