Removing A Disc; Manually Ejecting A Disc - Compaq PRESARIO Presario 1800 Setup Manual

If your Notebook power is off,
you will not be able to eject
a disc from the CD or DVD
drive. To remove a disc without
powering up your Notebook,
you must manually eject the
disc from the drive.
P N B
RESARIO OTEBOOK EYOND
1800 S
ERIES

Removing a Disc

To remove a disc from the drive,
complete the following steps:
1. Press the Eject button on
the drive.
2. Remove a disc from the tray, gently pushing down on the
centre spindle while pulling up on the outer edges. Avoid
touching the surface of the disc.
3. Push the tray back into the drive until it locks into place.

Manually Ejecting a Disc

If you need to eject a disc when the power is off, complete the
following steps to eject the disc manually:
1. Make sure the power is off and any external power sources
are disconnected.
2. Insert a small rod or pin, such as a paper clip (approximately
1/16 inch in diameter and at least 3/8 inch in length) into
the Manual Eject Hole and push firmly as shown in the
figure above.
3. Remove the disc from the tray.
4. Gently push the tray back into the drive until it locks
into place.
S G
ETUP UIDE
U CD DVD D
SING THE OR RIVE
5-3