Applied Control; Setup Of Selecting Function Indoor Unit - Carrier TOSHIBA MMU-UP0071HP-UL Service Manual

9-1. Setup of Selecting Function in Indoor Unit
(Be Sure to Execute Setup by a Wired Remote Controller)
<RBC-AMT***>
1
Push the + +
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in group
control.
Then the fan and louver of the selected indoor unit move.
UNIT LOUVER
2
Each time the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan and louver of the selected indoor unit move.
3
TEMP.
Use the button to select the CODE No. (DN code) of the
desired function.
4
Use the button to select the desired SET DATA
associated with the selected function.
5
Push the button. (The display changes from flashing to
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
When the button is pushed, the system returns to normal
off state.

9. APPLIED CONTROL

buttons simultaneously and hold for at
button (left side of the button) is pressed,
2
3
.
- 42 -
.
10
CODE No.
SET DATA 00 01 SETTING TEST
UNIT No. 1-1
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
5 4
3
1 2
6