NEC N8105-65 User Manual page 33

Precautions for Handling of Internal Devices
Do not disassemble, repair, or modify the product yourself
Do not disassemble, repair, or modify this product. Doing so may cause an electrical
shock or a fire. Do not put the product close to fire, or immerse it in water. Doing so may
cause an explosion. If the product does not function normally, contact your service
representative.
Unplug all power cords
Turn the power off and unplug the power before removing the computer's cover. Failure to
do so could endanger you and may damage the adapter or computer
Avoid installation in extreme temperature conditions.
Immediately after the server is powered off, its internal components such as heat sink are very hot.
Leave the server until its internal components fully cool down before installing/removing any
component.
Ground yourself to dissipate any static charge before handling the adapter.
To prevent any damage on components due to static electricity, make sure to discharge
static electricity from yourself before you touch the adapter.
Don't touch uncoated metal parts on adapter.
Never touch the adapter's terminals of components or uncoated metal parts on adapter.
Otherwise, taint, erosion or others may cause loose connection. Do not touch this
product with wet or dirty hands.
Excessive force could break the connector.
On installing this adapter, do not insert it by force. Otherwise, the adapter and the
server may be damaged.
Don't touch the tip of bracket to other parts of server.
When you insert the adapter into expansion slot, be careful not to touch the tip of bracket
to other parts of server (such as other components or board). Otherwise, they may be
damaged.
Firmly connect the cable
When connecting the cable, insert the cable connector firmly.
Do not unplug the power cord by holding the cable part.
Pull the power cord straight out by holding the plug. Pulling the power cord by holding the
cable part or applying extra pressure to the connector may damage the cable part, which
may cause a fire or electric shock.
Don't operate with dust on the front or inside of the device. Clean it regularly.
Continued operation with dust on the front or inside of the device may cause a fire. If you
need to clean the inside of the device, contact the store where you purchased the
product or a maintenance service company.
Don't attach or remove this product with the disinfectant attached to your fingers.
Don't install or remove optional products with the disinfectant on your fingers. If the
disinfectant adheres to the machine, it may corrode and cause malfunction, smoke or fire.
E-6