ELEVEN Free Manual page 23

Bass
The Bass control determines the amount of low
end in the amp tone. The response of this con-
trol in some models is linked to the setting of
the Treble control. The default setting is 5.0.
Bass range is from 0 to 10.
Middle
The Middle control determines the mid-range
strength in lower gain sounds. With high gain
amp models, the Middle control has a more dra-
matic effect and can noticeably shape the sound
of the amp at both the minimum and extreme
settings. The default setting is 5.0. The Middle
range is from 0 to 10.
Treble
In most amp models, the Treble control is the
strongest of the three tone controls. Its setting
determines the blend and strength of the Bass
and Middle controls. When Treble is set to
higher values, it becomes the dominant tone
control, minimizing the effect of Bass and Mid-
dle controls. When Treble is set to lower values,
the Bass and Middle have more effect, making
for a darker amp tone. The default setting is 5.0.
The Treble range is from 0 to 10.
Presence
The Presence control provides a small amount of
boost at frequencies above the treble control.
Presence is applied at the end of each amp
model pre-amp stage, acting as a global bright-
ness control that is independent of other tone
controls. The default setting is 3.0. The Presence
range is from 0 to 10.
Master
The Master control sets the output volume of
the pre-amp, acting as a gain control for the
power amplifier. In a standard master-volume
guitar amp, as the Master volume is increased
more power tube distortion is produced. The de-
fault setting is 5.0. Master range is from 0 to 10.
Some might assume a Master volume knob
capable of silencing the amp completely.
Not so. Use the Output knob (in the Master
section) to silence the output of the plug-in.
Use Master volume for tone and distortion.
Tremolo
Tremolo is achieved through the use of ampli-
tude modulation, multiplying the amplitude of
the pre-amp output by a waveform of lower fre-
quency. Tremolo is not available on all amps.
Tremolo Speed
The Speed control sets the rate of the Tremolo
effect. The Tremolo Speed LED pulses at the rate
of Tremolo Speed. The default setting is 5.0.
Eleven Free does not support Tempo Sync.
Tremolo Depth
The Depth controls the amount of the Tremolo
effect. The default setting for this control is 0.0,
which is equivalent to off.
Chapter 4: Using Eleven Free 19