Ferroli RIMINI DP Instructions For Installation And Use Manual page 56

RIMINI DP
RIMINI DP
PROGRAMMABLE DIGITAL FLUID ELECTRIC THERMAL EMITTER
1. PRESENTATION
Dear customer:
Thank you for choosing RIMINI DP electric thermal emitters, with their sophisticated design,
state-of-the-art electronics (touch keys), and high reliability (TRIAC), smart control for maximum
efficiency and high build quality. They comply with the Ecodesign Directive and are designed
and made in Spain.
The RIMINI DP thermal emitters of FERROLI, as well as all their materials and components
have passed strict controls to ensure their quality.
Before switching the emitter on, you must carefully read these instructions which will help you to
ensure correct operation of the device with maximum performance and complete satisfaction.
Keep them close by in case of any doubts.
2. LOCATION
The ideal place to locate the emitter is as close as possible to the coldest wall in the room.
It is not recommended to install the emitter on external walls without any insulation, however, in
this case, the section of wall behind the thermal emitter must be insulated.
In bathrooms, the electric thermal emitter must be installed outside the protective area, accord-
ing to the regulations in force (zone 3 in the picture).
Classification of the bathroom zones
Under no circumstances may the thermal emitter be located under an electrical outlet.
EN
56 A73021553