Care And Cleaning - GE PXRQ400T Owner's Manual & Installation Instructions

Care and Cleaning

CARTIDGE LIFE AND REPLACEMENT
When the filter indicator on the reverse osmosis assembly flashes or stays on, it's time to replace your filter.
The number indicate which filters need to be replaced. The pre- and post- filter should be replaced at the same time
(Filter#1 & filter#2).
See instructions below.
PREFILTER / POSTFILTER CARTRIDGE
REPLACEMENT (every 6 months)
Complete the following steps to replace the prefilter and
postfilter cartridges. Skip to step 3 if it is the first time
installing the filter.
1. Remove (turn counterclockwise) the prefilter cartridge
from the manifold. Then remove the postfilter
cartridge.
2. Discard the cartridges in a proper manner.
3. Remove wrapping from the new filters.
4. Install new cartridges in reverse order: postfilter first,
then prefilter. Turn cartridges clockwise to reattach to
the manifold. Do not overtighten.
5. Reset the timer by holding down the button for prefilter
(Filter#1) for 3 seconds or until the light flashes and
turns OFF. Repeat the same step for the postfilter
(filter#2).
6. Once filters are installed, Purge the Reverse Osmosis
system. See previous page for instructions.
7. When the purging is finished, close the faucet and
your Reverse Osmosis system is ready for use.
To obtain replacement filters, call toll-free GE Appliances Parts and Services at 1-800-952-5039, or
visit the store where you purchased your reverse osmosis system.
Prefilter /Postfilter Cartridge Replacement
Reverse Osmosis Cartridge Replacement
49-6000289 Rev. 0
REVERSE OSMOSIS MEMBRANE
CARTRIDGE REPLACEMENT
(every 12 months)
Complete the following steps to replace the RO
membrane. Skip to step 3 if it is the first time installing
the filter.
1. Remove the Reverse Osmosis cartridge by turning
clockwise.
2. Discard the cartridges in a proper manner.
3. Remove wrapping from the new reverse osmosis
membrane.
4. Install new cartridge by turning clockwise into the
manifold. Do not overtighten.
5. Reset the timer by holding down the button for the RO
membrane (Filter#3) for 3 seconds or until the light
flashes and turns OFF.
6. Once filter is installed, Purge the Reverse Osmosis
system. See previous page for instructions.
7. When the purging is finished, close the faucet and
your Reverse Osmosis system is ready for use
FQ400PT
FQ400MT
15