Epson WorkForce 840 Start Here page 2

3
S hake the ink cartridges gently 4 or 5 times, then unpack
them.
4
Remove only the yellow tape from each cartridge.
C aution: Don't remove any other seals or the cartridges may
leak.
5
I nsert the cartridges in the holder for each color. Press
each cartridge down until it clicks.
6
C lose the cartridge cover. Press down until it clicks.
Then lower the scanner.
7
P ress the OK button to prime the ink delivery system.
This takes about 5 minutes.
N ote: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
C aution: Don't turn off the printer while it is priming or you'll
waste ink.
5
Load paper
You can load letter-, A4-, or legal-size paper, as well as
4 6-, 5 7-, or 8 10-inch photo paper in cassette 1. For
instructions on loading legal-size paper, see the online User's
Guide. In cassette 2, you can load only letter, A4, or legal-size
plain paper.
1
Pull out paper cassette 1.
2
P osition the guide shown below for the size of paper
you're using.
4 6-inch
3
I nsert the paper with the glossy or printable side face-
down.
4 6-inch
N ote: Make sure the paper is loaded against the edge guide
and not sticking out from the end of the cassette.
4
S lide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
4 6-inch
5
Gently insert the paper cassette.
N ote: The paper may slide forward slightly as you insert the
cassette. This is normal.
6
F ollow steps 1 to 5 to load plain paper in cassette 2.
Remove the clear plastic cover before loading paper,
then replace it after paper is loaded.
7
Extend the output tray as shown.
Letter or A4-size
Letter or A4-size
Letter or A4-size