Daily Use - Washing & Drying - AEG LWR7485M4U User Manual

Table of Contents

Advertisement

In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
11.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start /
Pause
Press the On/Off button to activate
the appliance again.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
12.1 NON-STOP programme -
Washing and drying mode
Not all programmes are
compatible with drying
mode.
In some washing programmes, you can
combine WASH and DRY mode for
running a complete wash&dry
programme. Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the DRY mode button once to
activate also the drying function. The
leds of the WASH and DRY
button.
• After 5 minutes from the end of the
washing programme
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
indicators come on. The indicators
and
display. The display also shows the
maximum recommended load for a
washing and drying programme (e.g.
5 kg for cottons).
When drying a large laundry
load, make sure that the
garments are not rolled up
and that are uniformly
distributed in the drum.
12.2 Washing and Drying -
Automatic levels
The default level is the cupboard dry
one. In some programmes
you can change the drying level.
1. Tap on the Auto Dry button
repeatedly until the display shows the
required dryness level. The indicators
in the display illuminate accordingly:
a.
Iron dry: for cotton
items;
b.
Cupboard dry: for
cotton and synthetic items;
ENGLISH
35
appear in the

Advertisement

Table of Contents
loading

Table of Contents