Daikin ATKL50UV16V3 Operation Manual page 7

Operation
Adjusting the Airflow Rate/SMELL PROOF/CHILD LOCK Operation
Adjusting the airflow rate
You can adjust the airflow rate to increase your comfort.
■
To change the airflow rate setting
[ .Z. FA NJ .
Press
• In DRY operation, the airflow rate setting cannot be changed.
• When the airflow is set to"�", quiet operation starts and noise
from the indoor unit will become quieter.
• In the quiet operation mode, the airflow rate is set to a weak level.
SMELL PROOF operation
The SMELL PROOF operation prevents unpleasant odour inside the indoor unit. This function is
available in both DRY and COOL operation.
■
To use SMELL PROOF operation
1. Before starting the operation, press
2 . Press to select the DRY or COOL operation .
(MoDE]
� . Air starts circulating about 1 minute after the operation is started.
3 . Pre ss
�
CHILD LOCK operation
Setting the CHILD LOCK disables all the buttons except when ECONO and POWERFULL button
press together for about 5 seconds.
□
To set the CHILD LOCK :
• Press � and � � - o_ W E_ R _ c � - 1 L�together for about 5 seconds.
• "-e"
will be displayed on the remote LCD. • If a button is pressed while CHILD LOCK is on,"
□
To CANCEL the CHILD LOCK
Press � and
" -e "
Disappears from the LCD.
NOTE
• Note on airflow rate setting
• At smaller airflow rates, the cooling effect is also smaller.
• Note on SMELL PROOF operation
• SMELL PROOF operation can prevent some odours, but not all.
• Notes on the operating conditions
• The air conditioner always consumes a small amount of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, turn off the circuit breaker.
• Operation outside the humidity or temperature range described in the table may cause a
safety device to disable the system.
Mode
Outdoor temperature: 20-(52~54
COOL
Indoor temperature: 18-32
Max. temperature varying model to model.
Indoor humidity: 80% max.
DRY
•
Each pressing of
D-EJ-D· - - - �
AUTO
Indoor unit quiet
However, if the POWER CHILL operation is started, air starts circulating
immediately.
together for about 5 seconds again.
owERC �
Operating conditions
°
C
changes the airflow rate setting in sequence.
(,t.FANJ
Airflow rate 1-5 (Low to High)
(+ FA N)
to set to Auto.
If operation is continued out of this range
°
C)*
• A safety device may activate to stop the
operation.
• Dew may form on the indoor unit and drip from it
when COOL or DRY operation is selected.
-e"
blinks.
6