Table of Contents
Advertisement
Never operate the machine under the influ-
ence of alcohol or drugs, or while you are
otherwise impaired.
When digging or using ground-engaging
attachments, be aware of buried cables.
Contact local utilities to determine the lo-
cations of services.
Pay attention to overhead power lines and
hanging obstacles. High voltage lines may
require significant clearance for safety.
Hydraulic oil or diesel fuel leaking under
pressure can penetrate the skin, causing
serious injury or infection.
• Do not use your hand to check for leaks.
Use a piece of cardboard or paper.
• Stop the engine, remove the key, and
relieve the pressure before you connect
or disconnect fluid lines.
• Make sure that all components are in
good condition. Tighten all connections
before you start the engine or pressurize
the system.
• If hydraulic fluid or diesel fuel penetrates
the skin, seek medical attention immedi-
ately.
• Continuous long term contact with hy-
draulic fluid may cause skin cancer.
Avoid long term contact and wash the
skin promptly with soap and water.
Keep clear of moving parts. Loose clothing,
jewelry, watches, long hair, and other loose
or hanging items can become entangled in
moving parts.
Wear protective equipment when appropri-
ate.
Do not attempt to remove material from any
part of the machine while it is being oper-
ated or while components are in motion.
2 - SAFETY INFORMATION
Make sure that all guards and shields are
in good condition and properly installed be-
fore you operate the machine. Never oper-
ate the machine with shields removed. Al-
ways close access doors or panels before
you operate the machine.
Dirty or slippery steps, ladders, walkways,
and platforms can cause falls. Make sure
these surfaces remain clean and clear of
debris.
A person or pet within the operating area
of a machine can be struck or crushed by
the machine or its equipment. Do not allow
anyone to enter the work area.
Raised equipment and/or loads can fall un-
expectedly and crush persons underneath.
Never allow anyone to enter the area un-
derneath raised equipment during opera-
tion.
Never operate the engine in enclosed
spaces as harmful exhaust gases may
build up.
Before you start the machine, be sure that
all controls are in neutral or park lock posi-
tion.
Start the engine only from the operator's
seat. If you bypass the safety start switch,
the engine can start with the transmission
in gear. Do not connect or short across
terminals on the starter solenoid. Attach
jumper cables as described in the manual.
Starting in gear may cause death or serious
injury.
Always keep mirrors, all lighting, and
Slow-Moving Vehicle (SMV) emblem clean
to provide the best possible visibility while
you operate the machine.
Operate controls only when seated in the
operator's seat, except for those controls
2-3
Advertisement
Table of Contents
