Package Contains - Stanley ST55 Instruction Manual

ENGLISH (Original Instructions)
Voltage Amperes
12.1 - 20.0 20
220-240 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0 20
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the
user must read the instruction manual before
use.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2020 XX ZX
Year of manufacturing

PACKAGE CONTAINS

The package contains:
1 Motor unit
1 Straight edge guide
1 Roller bearing guide
1 Template guide
22
Cable rated current (Ampere)
20 25 - -
6 6 6 6 6
6 6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 25
Direct Current
n No-Load Speed
0
Class II
Construction
Earthing
Terminal
Safety
Symbol
/min. Revolutions or
Reciprocation
per minute
2 Wrenches
1 Straight milling cutter
-
2 Collets (6.35mm and 6mm)
6
1 Instruction manual
• Check for damage to the tool, parts or accessories
6
which may have occurred during transport.
15
• Take the time to thoroughly read and understand this
manual prior to operation.
15
FEATURES (Fig A)
20
WARNING: Never modify the power tool or any
-
part of the tool, otherwise it may cause damage
to the tool or result in personal injury.
1. On/off switch
2. Brush cap
3. Motor unit
4. Spindle
5. Collet
6. Collet nut
7. Cutter bit
8. Knob
9. Base
10. Gear
11. Straight edge guide
12. Roller bearing guide
13. Chip deflector
14. Plate
15. Plate screws
16. Wrench #10mm
17. Wrench #17mm
18. Template guide
ASSEMBLY
WARNING: To reduce the risk of injury, turn unit
Alert
off and disconnect machine from power source
before installing and removing accessories,
before adjusting or changing set-ups or when
making repairs. Be sure the rocker switch is in
the OFF position. An accidental start-up can
cause injury.
Cutter Bit Assembly (Fig B)
Wearing protective gloves while fitting and changing router
bits is recommended.
1. Reverse the unit;
2. Use wrench #10mm (16) to lock the spindle (4),
meanwhile anticlockwise rotate wrench #17mm (17) to
release the collet nut (6);
3.Take out the collet nut (6) and replace the collet (5) if
required;
4. Insert the shaft of cutter bit in the collet (5) then tighten
the collet nut (6) by wrench #10 (16) and wrench #17 (17);
5. Apply the reverse procedure to remove the cutter bit.