Lowering Of A Load; Operation With Pulley; Care, Maintenance And Repair; Care By Cleaning - unicraft ESW Series Operating Instructions Manual

Care, Maintenance and Repair

8.4 Lowering of a load

NOTE!
The rope must not be completely unwound! At least 5
windings must remain on the drum. If the red marking
becomes visible, the winch must be stopped immedi-
ately.
When lowering a load, note that the winch may still run a
few centimetres after stopping, so stop in good time.
Step 1: Lower the load smoothly and evenly.
CAUTION!
Risk of crushing!
When the load is lowered, the upper and lower limbs
may be crushed.
- Do not hold the upper and lower limbs between the
load and the ground when putting down the load.
Step 2: Place the load on a firm, safe surface.
Step 3: After lowering the load, open the safety catch on
the load hook and lower the load.

8.5 Operation with pulley

Fig. 7: Operation with pulley (left)
Step 1: Unscrew the cover from the load hook with pulley
and place the steel cable on the pulley. Screw
the cover back on. Check that the cable runs se-
curely on the pulley and that the screws are tight.
Step 2: Connect the load hook on the steel cable into the
suspension device on the housing (Fig. 7 bottom
left).
12
9 Care, Maintenance and Repair
ATTENTION!
The electrical cable winch must be disconnected
from the power supply system before starting any
maintenance, servicing or repair work!

9.1 Care by cleaning

The electrical cable winch must always be kept in a
clean condition.
Use protective gloves!
NOTE!
Never use strong cleaning agents to clean the device.
Such cleaning agents might damage or destroy the
device.
All plastic parts and painted surfaces should be cleaned
with a soft, damp cloth and some neutral cleaner.
Remove excess grease or oil with a dry, lint-free cloth.
NOTE!
Oil, grease and cleaning agents are hazardous to the
environment and must not be added to waste water or
normal household waste. Dispose of these agents in
an environmentally friendly manner. The cloths
soaked in oil, grease or cleaning agents are easily
combustible. Collect the rags or the cleaning wool in a
suitable, closed container and dispose of them in an
environmentally friendly manner - do not dispose of
them with your household waste!

9.2 Maintenance and repair

ATTENTION!
- Maintenance and repair works must only be per-
formed by specialists.
- Use only original spare parts in case of a repair.
If the electrical cable winch is not functioning properly,
contact a specialised dealer or our customer service.
Please find the contact data on chapter 1.2 Customer
service.
Immediately reassemble all protective and safety equip-
ment after completing the repair and maintenance of the
device.
ESW-Series | Version 1.08