GE Just Cut ConstantON 17140 Assembly Instructions

GE Branded Christmas Trees
with Easy Shape Technology
allows tree branches to spring into shape
Easy Light Technology
eliminates cord connections
Assembly Instructions
Nicolas Holiday Inc. thanks you for purchasing this pre-lit Christmas
tree. Should you have any problems with your tree, visit us at
www.geholidaylighting.com
toll free number at 1-877-398-7337.
Check our website for latest service hours and assembly instruction videos.
1. Carefully unpack, removing any bubble wrap and inspect the
contents of your tree. {Fig. A}
A
A
The tree stand should be open and set at 90 angle.
Remember to tighten the thumbscrew after
connecting section A and tree stand. See {Fig. B}
Untwist the red metal tie wrap holding the
branches in place.
Gently position any branches that do not fall
into place.
C
NOTE: No tools required
Tree Sections
7.5 ft trees 3
DISCLAIMER
: DO NOT USE OR INSTALL ANY ADDITIONAL CHRISTMAS
LIGHTING OR ORNAMENTATION THAT IS POWERED BY A LIGHT BULB
SOCKET. DOING THIS MAY RESULT IN DAMAGE TO YOUR CHRISTMAS
TREE OR CAUSE PERSONAL INJURY. DOING THIS, WILL RESULT IN A
VOID OF THE LIMITED WARRANTY OF THIS PRODUCT.
Disconnect the decorative item from the power source before
performing any maintenance or cleaning.
For indoor use only
THIS IS NOT A TOY, FOR DECORATIVE USE ONLY.
GE is a trademark of General Electric Company
and is under license by Nicolas Holiday Inc.
Distributed by Nicolas Holiday Inc.,
©2019 Nicolas Holiday Inc.,9 F., No. 37, Guangfu North Rd.
Taipei, Taiwan 10560
120V Printed in China
8.25"x11.25"
®
®
for more information. You can call our
B
B
2. When you connect two tree sections,
it is important that you align the mark
on the tree poles. See {Fig. C}
Tree Stand Approx. Asm Time
Metal 10 – 15 minutes
All rights reserved.
ESY19-ONEPLUG
TREE ASSEMBLY DIAGRAM
TOP
TOP
B
A
90
B
Thumbscrew
3. Assemble section by section. Firmly seat both sections together.
Note: Always unplug this product before installing.
Do not plug in tree to a power outlet until the entire tree is assembled.
Troubleshooting Tips
If the tree does not illuminate, try stepping on the ON/OFF Foot Pedal and make certain
the wall switch is turned on.
If one section of your tree does not illuminate, check that section for loose or missing bulbs,
all factory connections are properly made or that you properly made all the electrical
connections between each tree section, i.e., tree plug to extension cord outlet.
Also, check the fused plug for a missing or burned out (open) fuse.
Tree Storage
1. Remove the tree's main extension cord plug from the wall outlet.
2. Starting at the top, disconnect the top and section B.
Step A: Gently fold the branches up
toward the center.
Care should be taken to avoid damage
to the lights.
3. Disconnect sections B and A.
4. Refer to the drawing on how to
repack your tree.
IMPORTANT: Store your carton neatly in a cool, dry location protected from
sunlight to prolong the tree life and to better keep the light sets in working order.
Do not place a heavy load on the carton to avoid damage to or crushing the carton
and tree inside.
ATTENTION:
Replaceable fused lamps - identified by the white colored ring at the top of the lamp holder.
Refer to the UL light string instructions when replacing these lamps.
Spare Parts: Your tree includes spare bulbs, replaceable fused bulbs and spare 3-amp fuses
as replacements for the lighting strings and (1) 5-amp fuse for the plug.
7.5'
ON/OFF
OPEN
Foot Pedal
7.5 FT TREES
B
A
TOP