GE 18204 Assembly Instructions

GE Branded Christmas Trees
with Easy Light Technology
eliminates cord connections
Color Choice
®
Assembly Instructions
Nicolas Holiday Inc. thanks you for purchasing this pre-lit Christmas
tree. Should you have any problems with your tree, visit us at
www.geholidaylighting.com
toll free number at 1-877-398-7337.
Check our website for latest service hours and assembly instruction videos.
1. Carefully unpack, removing any bubble wrap and inspect the
contents of your tree. {Fig. A}
You should have section A, B, & Top for 7' tree.
A
A
The tree stand should be open and set at 90 angle.
Remember to tighten the thumbscrew after
connecting section A and tree stand. See {Fig. B}
Untwist the red metal tie wrap holding the
branches in place.
Gently position any branches that do not fall
into place.
C
NOTE: No tools required
Tree Sections
7 ft trees 3
* Does not include time for shaping branches, estimated shaping time is 30 minutes/section.
DISCLAIMER
: DO NOT USE OR INSTALL ANY ADDITIONAL CHRISTMAS
LIGHTING OR ORNAMENTATION THAT IS POWERED BY A LIGHT BULB
SOCKET. DOING THIS MAY RESULT IN DAMAGE TO YOUR CHRISTMAS
TREE OR CAUSE PERSONAL INJURY. DOING THIS, WILL RESULT IN A
VOID OF THE LIMITED WARRANTY OF THIS PRODUCT.
Disconnect the decorative item from the power source before
performing any maintenance or cleaning.
For indoor use only
THIS IS NOT A TOY, FOR DECORATIVE USE ONLY.
GE is a trademark of General Electric Company
and is under license by Nicolas Holiday Inc.
Distributed by Nicolas Holiday Inc.,
©2018 Nicolas Holiday Inc.,9 F., No. 37, Guangfu North Rd.
Taipei, Taiwan 10560
120V Printed in China
8.25"x11.25"
®
LED Technology
for more information. You can call our
B
B
2. When you connect two tree sections,
it is important that you align the mark
on the tree poles. See {Fig. C}
Approx. Asm Time *
Tree Stand
Metal 10 – 15 minutes
All rights reserved.
HG18-DUAL-ONEPLUG-MICRO
TREE ASSEMBLY DIAGRAM
TOP
B
A
TOP
B
3. Assemble section by section. Firmly seat both sections together.
Note: Always unplug this product before installing.
90
Do not plug in tree to a power outlet until the entire tree is assembled.
4. To change colors,
step on the color
change foot pedal
Thumbscrew
to the desired
function as listed on
the back of the
foot pedal.
Troubleshooting Tips
If the tree does not illuminate, try stepping on the On/Off FOOT PEDAL and make
certain the wall switch is turned on.
If one section of your tree does not illuminate, check that section for loose or missing
bulbs, all factory connections are properly made or that you properly made all the
electrical connections between each tree section, i.e., tree plug to extension cord outlet.
Tree Storage
1. Remove the tree's main extension cord plug from the wall outlet.
2. Starting at the top, disconnect the top and section B).
Step A: Gently fold the branches up toward the center.
Care Should be taken to avoid damage to
the lights.
3. Disconnect sections B and A.
4. Refer to the drawing on how to
repack your tree.
IMPORTANT: Store your carton neatly in a cool, dry location protected from
sunlight to prolong the tree life and to better keep the light sets in working order.
Do not place a heavy load on the carton to avoid damage to or crushing the carton
and tree inside.
NO Spare Parts
7 FT
Color Change
Foot Pedal
7 FT TREES
B
A
0218
TOP