Subscribe to Our Youtube Channel
Related Manuals for Keystone E31250
Summary of Contents for Keystone E31250
- Page 1 THE SLX 250 TON SQUARE SHOULDER ELEVATOR OPERATING PROCEDURE MANUAL OP-09 REV.08 07/19/2022...
-
Page 2: Table Of Contents
6.0 Replacement parts 7.0 Wear data 8.0 Wear Data 9.0 Wear Data 10.0 Wear Data 11.0 Reception, Storage, Transport & Decommissioning Certificate of warranty & guarantee of quality Manufacture Information & Revision History Keystone Keystone ENERGY TOOLS ENERGY TOOLS OP-09 REV.08 07/19/2022... - Page 3 Failure to inspect these parts could cause injury or death. ⚠WARINING: Do not use oversized pipe. Using oversized pipe could make it difficult or impossible to properly latch the elevator. Keystone DO NOT DISCARD – GIVE TO USER ENERGY TOOLS OP-09 REV.08 07/19/2022...
- Page 4 ⚠WARINING: For professional use only. Maintenance Hazards ⚠WARINING: Use only Keystone Energy Tool components on equipment. Failure to do so may affect the correct functioning of the tool and may cause injury or death.
-
Page 5: Safety Instructions
1.0 Introduction This manual contains operation and maintenance Model Range Tons instructions for the Keystone Energy Tools (KET) “SLX-250” series, Square Shoulder Side Door E31250 SLX-250 5” – 8 5/8” Elevators for handling casing or drill collars with E33650 SLX-250 9 5/8”... -
Page 6: Maintenance
• Check springs for damage, deformation and lack of tension. Lubricate the elevator regularly during usage and storage to prevent corrosion. Use an extreme pressure, multi- purpose, lithium base grease of No. 1 or No. 2 consistency or a lubricant that meets MIL-SPEC-A907E. Keystone ENERGY TOOLS OP-09 REV.08 07/19/2022... -
Page 7: Maintenance & Inspection
Bolt Daily Grease Underside of If any repair work is required, the equipment shall be Lifting Eye sent into a Keystone Energy Tool facility for Grease Bore and evaluation. Seating Surface Every 6 Months “Performance Load Test” is recommended after 365 MPI Category III days of accumulative use. - Page 8 • If either link block is to be replaced, remove the link Bodies, doors and latches are specifically matched block bolt and cotter pins. by trained Keystone Energy Tools professionals. For • Reassemble by reversing the above steps. this reason, a body, door or latch from one elevator should never be exchanged with a body, door, or •...
-
Page 9: Technical Drawings
5.0 Elevator Technical Drawings *NOTE – PAINT CAN NOT EXCEED A THICNKESS OF 0.2mm Keystone ENERGY TOOLS OP-09 REV.08 07/19/2022... -
Page 10: Replacement Parts
6.0 Replacement Parts ⚠WARINING: Use only Keystone Energy Tool components on equipment. Failure to do so may affect the correct functioning of the tool and may cause injury or death. ITEM PART No. DESCRIPTION E8145-1 UPPER LINK BLOCK BOLT, NUT, COTTER... - Page 11 7.0 Wear Data for SLX Elevators Keystone Keystone ENERGY TOOLS ENERGY TOOLS OP-00 Rev A OP-00 Rev A OP- Rev A OP-09 REV.08 07/19/2022...
- Page 12 8.0 Wear Data for SLX Elevators Keystone Keystone ENERGY TOOLS ENERGY TOOLS OP-00 Rev A OP-00 Rev A OP- Rev A OP-09 REV.08 07/19/2022...
- Page 13 9.0 Wear Data for SLX Elevators Keystone Keystone ENERGY TOOLS ENERGY TOOLS OP-00 Rev A OP-00 Rev A OP- Rev A OP-09 REV.08 07/19/2022...
-
Page 14: Reception, Storage, Transport & Decommissioning
Always wear gloves and safety goggles when disassembling the tool. Clean the tool with a steam cleaner. It is recommended to disassemble the tool in a place where drainage for waste fluids is possible. Keystone Keystone ENERGY TOOLS ENERGY TOOLS... -
Page 15: Certificate Of Warranty & Guarantee Of Quality
Buyer’s sole and only remedy in regard to any defective materials or products shall be the repair or replacement thereof as herein provided, and seller shall not be liable for any consequential, special, incidental or punitive damages resulting from or caused by any defective materials, products or supplies. Keystone ENERGY TOOLS OP-09 REV.08 07/19/2022... -
Page 16: Keystone
Keystone ENERGY TOOLS For more information, please contact us at: Keystone Energy Tools 3711 Melancon Rd. Broussard, LA 70518 www.k-e-t.com Office: 1-337-365-4411 Fax: 1-337-365-4456 Revision History Revision Date Changes 05/26/2021 Format update/revision history added 09/21/2021 Updated SLX wear Data f/all Frame Sizes...
Need help?
Do you have a question about the E31250 and is the answer not in the manual?
Questions and answers