Related Manuals for Keystone SJ-30
Summary of Contents for Keystone SJ-30
- Page 1 THE SINGLE JOINT 7.5 TON BOTTLENECK & CASING ELEVATOR OPERATING PROCEDURE MANUAL OP-06 REV.09 02/06/2023...
-
Page 2: Table Of Contents
Figure 8 – critical area map 5.0 Technical drawings 6.0 Replacement parts 7.0 Wear data 8.0 Reception, storage, transport, decommissioning Certificate of warranty & guarantee of quality Manufacture Information & Revision History Keystone Keystone ENERGY TOOLS ENERGY TOOLS OP-06 REV.09 02/06/2023... -
Page 3: Vertical Vs Horizontal Lifts
Failure to inspect these parts could cause injury or death. ⚠WARINING: Do not use oversized pipe. Using oversized pipe could make it difficult or impossible to properly latch the elevator. Keystone DO NOT DISCARD – GIVE TO USER ENERGY TOOLS OP-06 REV.09 02/06/2023... - Page 4 Figure 4: Shows the correct way the elevator should be latched with the safety latch lock pin when the safety latch lock pin is used incorrectly. installed Keystone DO NOT DISCARD – GIVE TO USER ENERGY TOOLS OP-06 REV.09 02/06/2023...
-
Page 5: Safety Instructions
⚠WARINING: For professional use only. Maintenance Hazards ⚠WARINING: Use only Keystone Energy Tool components on equipment. Failure to do so may affect the correct functioning of the tool and may cause injury or death. -
Page 6: Safety Instructions
1.0 Introduction This manual contains operation and maintenance instructions for the Keystone Energy Tools (KET) “SJ” Model Tons Range series single joint elevator and provides instruction for its proper field use, disassembly and repair; including a SJ-30 4” – 5 7/8”... -
Page 7: Maintenance & Inspection
• Check springs for damage, deformation and lack of tension. Lubricate the elevator regularly during usage and storage to prevent corrosion. Use an extreme pressure, multi- purpose, lithium base grease of No. 1 or No. 2 consistency or a lubricant that meets MIL-SPEC-A907E. Keystone ENERGY TOOLS OP-06 REV.09 02/06/2023... -
Page 8: Maintenance & Inspection
Every 12 Months MPI Category IV Performance Load Every 365 Days If any repair work is required, the equipment shall be “See left” Test sent into a Keystone Energy Tool facility for Figure 7 evaluation. Keystone ENERGY TOOLS OP-06 REV.09 02/06/2023... -
Page 9: Repair
Bodies, doors and latches are specifically matched • To remove the Hinge Pin, first remove the Hinge Pin by trained Keystone Energy Tools professionals. For Retainer Pin. Drive out the Hinge pin from the bottom this reason, a body, door or latch from one elevator of the elevator. -
Page 10: Technical Drawings
5.0 Elevator Technical Drawings *NOTE – PAINT CAN NOT EXCEED A THICNKESS OF 0.2mm Keystone ENERGY TOOLS OP-06 REV.09 02/06/2023... -
Page 11: Replacement Parts
LATCH PIN RETAINER (SAME AS HINGE) E316RP HINGE PIN REATAINER (SAME AS LATCH) ⚠WARINING: Use only Keystone Energy Tool components on equipment. Failure to do so may affect the correct functioning of the tool and may cause injury or death. Keystone ENERGY TOOLS OP-06 REV.09 02/06/2023... -
Page 12: Wear Data
7.0 Wear Data for Single Joint Elevators Keystone Keystone ENERGY TOOLS ENERGY TOOLS OP-00 Rev A OP-00 Rev A OP- Rev A OP-06 REV.09 02/06/2023... -
Page 13: Reception, Storage, Transport, Decommissioning
Always wear gloves and safety goggles when disassembling the tool. Clean the tool with a steam cleaner. It is recommended to disassemble the tool in a place where drainage for waste fluids is possible. Keystone Keystone ENERGY TOOLS ENERGY TOOLS... -
Page 14: Certificate Of Warranty & Guarantee Of Quality
Buyer’s sole and only remedy in regard to any defective materials or products shall be the repair or replacement thereof as herein provided, and seller shall not be liable for any consequential, special, incidental or punitive damages resulting from or caused by any defective materials, products or supplies. Keystone ENERGY TOOLS OP-06 REV.09 02/06/2023... -
Page 15: Manufacture Information & Revision History
Keystone ENERGY TOOLS For more information, please contact us at: Keystone Energy Tools 3711 Melancon Rd. Broussard, LA 70518 www.k-e-t.com Office: 1-337-365-4411 Fax: 1-337-365-4456 Revision History Revision Date Changes 05/26/2021 Format change/rev history added 10/18/2021 Added Category III & IV definitions...