Operation; Installation - Palmgren 9680149 Operating Manual & Parts List

Palmgren Operating Manual & Parts List
SAFETY RULES (CONTINUED)
GROUNDING INSTRUCTIONS
This machine has a three-prong plug, the third prong is the ground.
Plug this cord only into a three-prong receptacle. Do not attempt to
defeat the protection the ground wire provides by cutting off the
round prong. Cutting off the ground will result in a safety hazard and
void the warranty.
WARNING: Do not modify the plug in any way. if you have any doubt,
call a qualified electrician.

INSTALLATION

CAUTION: Do not attempt to use the machine until installation is
complete, and all preliminary checks have been made in accordance
with this manual.
MOUNTING THE MACHINE
The machine should be mounted on a strong, heavy workbench, of
sufficient height so that you do not need to bend your back to
perform normal operations. 9680149 comes with a stand, but can
also be mounted to workbench.
Ensure the location is adequately lit and that you will not be working
in your own shadow. We strongly recommend that the machine
bolted firmly to strong workbench using the tapped holes used to
secure the feet to the machine. This is to provide added stability and
consequently, additional safety.
To do this, first drill four M12 clearance holes in a worktop, at the
dimensions shown in the diagram opposite, and with appropriate
length M10 bolts, or screws, with flat washers. (not supply, you need
prepare these by yourself ).
Figure 2 - Clearance holes in worktop diagram.

OPERATION

Before starts to use this machine, operator should go through the
instructions carefully so as to acquaint with the construction of the
machines, the functions of the various controls and also the driving
systems.
Let me introduce the operator step to you:
1. Insert the power line insert the socket left of the fuselage, then
power on.
Figure 3 – Power plug socket locations.
2. Loosen the emergency stop switch (B), then the spindle speed
display (D) bright and show "0000" , press the start button (A) then
clockwise rotation of the speed control button (C), can make the
spindle speed raise to the highest position. Under these
circumstances the mill only have forward direction. Under
tapping circumstances have forward and reverse direction. Press
the tapping function lock button (E), then is button will bright,
then you can press a green button to choose the spindle run to
forward or reverse. The green button total 3 pieces., they on the
right of the spindle box in the lifting lever. You can see the word
of forward or reverse on the right of the display (D), it easy to
show the user the direction of the rotation of the spindle.
F
G
Figure 4 – Main control buttons.
A – Start
B – E-stop
C – Speed control dial
D - Display
3. This mill has two spindle speed ranges. The low is 100-1800 rpm
and the high range is 280-5000 rpm. To switch between the
ranges, un plug the machine, open the cover, and switch the belt
between the two gear sets.
4
9680149
D
C
E
A
B
E – Tapping mode/drill mode
F – Up button
G – down button
H – power indicator light