Power Requirements; Warranty - EarthQuaker Devices Aurelius Manual

• For standard latching operation: Tap the footswitch once to activate the
effect and then tap again to bypass.
• For momentary operation: With the effect off, hold the footswitch down
for as long as you'd like to use the effect. Once you release the switch, the
effect will be bypassed.
NOTE: HOLDING THE BYPASS SWITCH DOWN WHILE AURELIUS
IS ACTIVATED WILL SWITCH INTO THE SELECTED PRESET MODE!
Since the switching is relay-based, it requires power to pass signal.

POWER REQUIREMENTS

Current Draw .........................75 mA
This device takes a standard 9 volt DC power supply with a 2.1mm negative
center barrel. We recommend using a pedal-specific, transformer-isolated,
wall-wart power supply or a power supply with multiple isolated-outputs.
Pedals will make extra noise if there is ripple or unclean power. Switching-
type power supplies, daisy chains and non-pedal specific power supplies do
not always filter dirty power and may result in unwanted noise.
DO NOT RUN AT HIGHER VOLTAGES! YOU HAVE BEEN WARNED.
TECH SPECS
Input Impedance ................. 500 kΩ
Output Impedance .................100 Ω

WARRANTY

This device has a limited lifetime warranty. If it breaks, we will fix it. Should you
encounter any issues, please visit www.earthquakerdevices.com/support.
9