Taco Marine GS-950 Installation Manual

GS-950 MOUNT INSTALLATION
FOR MASTHEAD ANCHOR LIGHT
1. Use the drill template to mark and drill with a 1/4" bit the three bolt holes.
2. If your top requires spacers, trim the included vinyl spacers to the depth of your
hardtop thickness. Insert the vinyl spacers into each bolt hole.
3. Place a bead of marine-grade sealant on the underside of the mounting plate. This
helps prevent water intrusion.
4. Securely bolt the base to the mounting surface. Be careful not to deform the top.
5. Connect wire according to Figures on page 7 and 8.
6. Use a 7A fuse in the main +12 VDC power feed (not included).
7. Use a 3A fuse for the light (not included).
8. Ensure the Black wire has a good connection to battery ground.
9. Operate the unit in both directions using the momentary switch.
• Horizontal adjustment is possible to 80° angle. See diagram A.
• The GS-950 features two set screws – one to lock the light positioning in place, the
other for adjustment.
10. Screw down the bottom of
the light tube assembly to
the mount.
NOTE: Before installing the
LED Light Tube, apply a thin
layer of marine grease, anti-
seize or teflon tape to the
threaded shaft.
4 / G S- 85 0 & 95 0 M OU NT
DIAGRAM A
Upper Adjustment Set Screw
Note: There are 2 set screws in
the hole. The outer screws locks
the set screw in place.
Adjustments to the arm position need to be done
slowly 1/4 turn at a time.
TACO Marine® | tacomarine.com | info@tacomarine.com
Lower Adjustment Set Screw
Note: There are 2 set screws in
the hole. The outer screws locks
the set screw in place.