Table of Contents
Advertisement
Amplitude is too
small.
Does not sharp
enough.
Does not function, but
LED flashes.
NOTE: The charging current fluctuates depending on the space between charging adaptor and
the coil. / Please follow the procedure below.
1. Put the coil and the bottom part of housing close together.
2. Put the bottom part of housing and the charging adaptor close
together.
3. Measure the charging currents between (+) terminal of battery and
lead wire comes from module side.
<CHECK DRIVING HEAD AMPLITUDE.>
Turn the switch ON, and measure the amplitude
using a pin of
drivin head. (See the figure as shown above.)
<CHECK MODULE.>
Take out the right battery. (Viewed from the front.)
Connect lead
wire with chassis and (-) terminal of battery. Check
charging current
between lead wire comes from module side (stated
on WIRING CON-
NECTION DIAGRAM) and (+) terminal of battery
setting on the normal
adaptor. Okay if it is more than 600mA when
connecting to rated
voltage.
8
NO Replace linear
motor.
(only the case
the
amplitude is
clear-
ance (2.8mm
full
wideth.))
NO
Replace module.
NO Replace module.
NO
Replace linear
motor.
Advertisement
Table of Contents
