Table of Contents
Advertisement
4.2. Waterproof Rubber
The waterproof rubber must be fitted the right way around. Install as shown in figure by
inserting firmly to the set position.
4.3. Trimmer
Set a position where marking
and hook lower side of two hooks. With a position 8mm
sliding down, hook right and left side of hooks at upside.
4.4. Module
Module is soldered with connection terminal of chassis.
Follow the step below to remove the module.
1. Unsolder four points A, B, C, and D.
2. Remove the module from four hooks with chassis.
5. TROUBLESHOOTING GUIDE
(Refer to WIRING CONNECTION DIAGRAM)
5
Advertisement
Table of Contents
