Fitting into a worktop
The portable induction hob can be inset into
a typical kitchen worktop, so long as the
following guides are considered:
Aperture required is 27cm x 50cm
◆
Allow adequate space/ventilation (well vented
◆
15cm gap) to the underside all round, special
consideration must also be given to the North
and South side air vents
work surface, ensure the angle is cut at 45°
to maximise the air flow. See Diagram A.
Ensure no ferrous (magnetic) metal is
◆
placed within 15cm under the hob.
We do not advice using a silicone
◆
mastic to seal the hob in place, simply
allow gravity to hold it in place.
Diagram A.
When cutting into a work surface, ensure
the angle is cut at 45° to maximise the air
flow to both north and south air vents
If cutting into a
10
10
45°
.
10