Advertisement
How to use the Hob
1. Plug-in the Hob to a socket.
2. A "beep" will sound to
confirm connection.
3. Place suitable cookware on one
or both heating zones
4. Touch the power switch
Then for each zone:
5. Touch
and the heating
zone will heat to Level 5.
6. The heat level can then be adjusted
by touching the
7. Pressing the
the heat setting - until the
touched and held to unlock.
8. After a heating zone
heated, the cooling fan
for one extra minute to cool the device.
Timer
You can set the timer
◆
the two heating zones
zones to the same time. Simply operate
the plus or minus controls for Timer.
Settings may be locked by pressing the
◆
control. Times can be set from
0 - 99 minutes.
Heating levels shown in power levels.
Hob temperatures can be set in 8 steps
Turn off the device by touching
◆
the power switch
/
.
.
and
controls.
control will lock
is
/
has been
will operate
for one of
/
, or both
.
How to clean the hob
The hob must be disconnected from
mains supply and completely cooled
down before cleaning.
Hob Plate: Clean with a warm
◆
soapy damp cloth, or occasionally
a proprietary Hob Cleaner.
Casing: Clean with a warm
◆
soapy damp cloth.
Air Circulation Ports: Wipe
◆
surfaces with a cotton bud, or
warm soapy damp cloth.
DO NOT immerse the
◆
Induction Hob in water.
Error messages
If a heating level is set when there is no
◆
cookware or unsuitable cookware on the
heating zone, the display will flash 'E'.
E0: Cookware not present, is not
◆
suitable for use with induction hobs
or has an induction base less than
12cm diameter; hob powers off and
"beeps" - use compatible cookware.
If the following messages are shown on
the display, please contact Judge at the
address given in the Warranty section.
E1: Overheating of IGBT or
◆
damage to thermal resistor
E2 or E5: Damage to temperature
◆
sensor/ dry boiling protection
E3: Too high or too low supply voltage
◆
Advertisement
