Section 4: Operations; Operation Overview - Grizzly T33304 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide
the novice machine operator with a basic
understanding of how the tool is used
during operation, so the tool controls/com-
ponents discussed later in this manual are
easier to understand.
Due to the generic nature of this overview,
it is not intended to be an instructional
guide. To learn more about specific opera-
tions, read this entire manual, seek addi-
tional training from experienced machine
operators, and do additional research out-
side of this manual by reading "how-to"
books, trade magazines, or websites.
To reduce your risk of
serious
this
BEFORE using tool.
Eye injuries, respiratory problems,
or hearing loss can occur while
operating this tool. Wear person-
al protective equipment to reduce
your risk from these hazards.
-14
-
injury, read
entire manual
To complete a typical operation, the
operator does the following:
1. Examines workpiece to make sure it is
suitable for routing.
2. Secures workpiece.
3. Installs router bit and adjusts depth for
operation.
4. Puts on safety glasses, hearing
protection, and respirator.
5. Places tool on workpiece without bit
contacting workpiece.
6. Turns tool ON, starts motor, waits for
bit to reach full speed, then begins cut
with even, steady motion.
Note: Always do a test run on a scrap
piece of wood or laminate to check that
depth of cut is accurately set.
7. Stops motor, allows bit to come to
complete stop, then lifts tool.
8. Repeats Steps 6–7 until desired result
is achieved.
If you are not experienced with this
type of machine, WE STRONGLY
RECOMMEND that you seek addi-
tional training outside of this man-
ual. Read books/magazines or get
formal training before beginning any
projects. Regardless of the content
in this section, Grizzly Industrial
will not be held liable for accidents
caused by lack of training.
Model T33304 (Mfd. Since 05/22)