Page 2
GRV 21 مشتری گرامی ضمن تشکر از حسن سلیقه و اعتماد شما به برند میگل امیدواریم .از کار با این دستگاه لذت ببرید مشخصات فنی ولتاژ خروجی شارژ ولتاژکاری ولتاژ/ فرکانس شارژر ورودی مدل 72 ولت 042-001 ولت 005 میلی آمپر...
Page 3
در صورت آسیب دیدن باطری، هرگز از دستگاه استفاده نکنید و جهت سرویس – 10 و یا تعویض قطعه با مراکز مجاز خدمات پس از فروش تماس حاصل نمایید، همچنین از باطری دستگاه برای کاربرد های دیگر استفاده نکنید در صورت خرابی و غیر قابل استفاده بودن باطری، هرگز آن را با زباله های خانگی –...
Page 4
مراقب باشید اعضای بدن مانند انگشت های دست، انگشت های پا در قسمت مکش .دستگاه قرار نگیرد قطعات دستگاه مخزن خاک پوشش فیلتر فیلتر هپا )جاروی جدا شدنی (جارو دستی باطری بدنه اصلی دستگیره برس کوچک سری تخت شارژر )پارویی (سری سطوح...
Page 5
نحوه وصل کردن قطعات کاربر می بایست با توجه به مواردی که در جمله های زیر آمده، قطعات دستگاه را .وصل کند 1 – نحوه سوار کردن دستگیره به بدنه اصلی با توجه به تصویر زیر دستگیره را به سمت قسمت باالیی بدنه اصلی بچرخانید تا بر .روی...
Page 6
کارکرد دستگاه :همانطور که در تصویر زیر مشاهده می کنید، این دستگاه دارای دو دکمه می باشد – 1 دکمه روشن/خاموش (1) و دکمه کنترل سرعت (2) که بر روی دستگیره تعبیه شده اند. با فشار دادن دکمه روشن/خاموش، موتور دستگاه فعال شده و دستگاه شروع به کارکردن...
Page 7
پس از جداسازی، دکمه روشن/خاموش روی جارو دستی (7)را فشار دهید تا روشن گردد و جهت خاموش کردن آن دکمه را مجددا فشار دهید. در صورت نیاز به استفاده هر کدام از ب ُ رس ها یا سری، مطابق شکل های زیر به راحتی می توانید آن ها را به جارو .دستی...
Page 8
نحوه شارژ باطری .مطابق شکل زیر، ابتدا سوکت آدابتور شارژر را به دستگاه متصل نمایید – 1 همانطور که در شکل زیر نشان داده شده،دوشاخه آداپتور را به پریز برق وصل – 2 نمایید، در این هنگام چراغ های نشانگر میزان باطری روشن شده و باطری دستگاه در حالت...
Page 9
جهت جدا نمودن مخزن خاک ابتدا قطعات جانبی را از جارو دستی جدا نمایید – 3 سپس با فشار دادن دکمه رهاسازی که در تصویر زیر قابل مشاهده می باشد مخزن خاک(2) را جدا نمایید ،دسته فیلتر داخل مخزن خاک (3)را با دست نگه دارید و آن را به بیرون بکشید سپس...
Page 10
.فیلتر هپا را زمانی می بایست تمیز نمایید که مکش دستگاه ضعیف شده باشد همیشه به یاد داشته باشید قبل از قرار دادن فیلتر هپا در جای خود آن را کامال .خشک کنید پس از پایان تمیزکاری، ابتدا فیلتر هپا را درون فیلتر اصلی قرار دهید، سپس –...
Page 11
- 10 .پیشنهاد می گردد پس از هر دفعه استفاده از دستگاه، مخزن خاک را تمیز نمایید .در صورت مسدود شدن فیلتر هپا، آن را تمیز و یا تعویض نمایید برای کارکرد بهتر دستگاه ب ُ رس پارویی را گاهی اوقات پس از چندین دفعه استفاده پ ُ رز های .داخل...
Fig 18 Scrape along the locating slot of rolling brush with blade (see Fig.19) to cut the hair and clean, then install the Floor brush well in position, after it, fasten the Release button of rolling brush. Fig 19 It is suggested that the Dust cup shall be cleaned in time after working each time.
Page 19
left on the Dust cup (see Fig.15). Fig 15 Grasp the Filter handle (3) and rotate it anticlockwise to remove the HEPA filter (6), then empty the rubbish in the Filter cover (5) and rinse it with water. Wipe the residual water left on the Filter cover (see Fig.16). Fig 16 Clean the HEPA filter (6) with water when the sucking performance degrades, but it must be dried completely after being cleaned.
Page 20
CHARGING OPERATION Insert the smaller end of Power adapter (8) into the charging hole of Sub unit by following the direction shown in Fig.12. Insert the larger end of Power adapter into socket (see Fig.13), the Battery indicators light up successively and the appliance enters into charging condition.
OPERATION 1. Operation for the whole appliance There are two switches including Power switch (1) and Speed control button (2) on the Handle (see Fig.7). Press down the Power switch (1), the motor and rolling brush activate and the appliance starts working, then you can use it for cleaning floor and carpet.
Page 22
1. Assemble the Body and Handle Rotate the Handle (1) by following the direction shown in Fig.1 to the corresponding position of Body (2) to make the Handle and Body be locked together (see Fig.2). 2. Assemble the Body and Floor brus Insert the Floor brush (1) into the Body by following the direction shown in Fig.3 until the Release button (2) be fastened to the body (see Fig.4).
KNOW YOUR VACUUM CLEANER Dust cup Filter cover HEPA filter Sub unit Battery pack Body Handle Small hair brush Flat suction spout Charger Floor brush ASSEMBLE THE APPLIANCE This appliance is a litter larger, so the Body, Floor brush, Charger, Charging base, Power adapter, Small air brush and Flat suction spout are packaged separately for convenient transportation and storage.
Page 24
Do not operate the appliance if the battery of charger is damaged or after malfunction or has been damaged in any manner. Return appliance to an authorized service facility for examination, repair or adjustment. Do not use the battery for other intended use. The charge battery must be disposed properly if it can no longer be used.
GRV 21 Dear customer! Thanks for your worthful choice and confidence to Migel brand. We really hope that you enjoy operating this product TECHNICAL DATA Model Working Voltage Charger input Charger output GRV 21 21.6 V 100-240 V 27.0V 0.5A...
Need help?
Do you have a question about the GRV 21 and is the answer not in the manual?
Questions and answers