Beko B5WFT510418WD User Manual page 44

• Softener dosage setting may be in low
level. >>> Increase the softener dosage
amount by one level. See "Automatic
Dosage Setting".
Detergent residue in the detergent
drawer. (**)
• Detergent was put in wet drawer. >>> Dry
the detergent drawer before putting in de-
tergent.
• Detergent has gotten damp. >>> Keep de-
tergents closed in an environment free of
humidity and do not expose them to ex-
cessive temperatures.
• Water pressure is low. >>> Check the wa-
ter pressure.
• The detergent in the main wash compart-
ment got wet while taking in the prewash
water. Holes of the detergent compart-
ment are blocked. >>> Check the holes
and clean if they are clogged.
• There is a problem with the detergent
drawer valves. >>> Call the Authorised
Service Agent.
• Detergent was mixed with the softener.
>>> Do not mix the softener with deter-
gent. Wash and clean the drawer with hot
water.
• Regular drum cleaning is not applied. >>>
Clean the drum regularly. For this proced-
ure, see Cleaning the Loading Door and
the Drum [} 39]
Too much foam forms inside the
product. (**)
• Improper detergents for the washing ma-
chine is used. >>> Use detergents appro-
priate for the washing machine.
• Excessive amount of detergent is used.
>>> Use only sufficient amount of deter-
gent.
• Detergent was stored under improper
conditions. >>> Store detergent in a
closed and dry location. Do not store in
excessively hot places.
• Some meshed laundry such as tulle may
foam too much because of their texture.
>>> Use smaller amounts of detergent for
this type of item.
• Detergent was put in the wrong compart-
ment. >>> Make sure you place the deter-
gent in the appropriate compartment.
Foam is overflowing from the detergent
drawer.
• Too much detergent is used. >>> Mix 1
tablespoonful softener and ½ l water and
pour into the main wash compartment of
the detergent drawer. >>> Put detergent
into the product suitable for the pro-
grammes and maximum loads indicated
in the "Programme and consumption
table". When you use additional chemic-
als (stain removers, bleaches and etc.),
reduce the amount of detergent.
Laundry remains wet at the end of the
programme. (*)
• Excessive foam has occurred and auto-
matic foam absorption system has been
activated due to too much detergent us-
age. >>> Use recommended amount of
detergent.
(*) The product does not switch to spinning
step when the laundry is not evenly distrib-
uted in the drum to prevent any damage to
the product and to its surrounding environ-
ment. Laundry should be rearranged and re-
spun.
(**) Regular drum cleaning is not applied.
Clean the drum regularly. See Cleaning the
Loading Door and the Drum [} 39]
If you cannot eliminate the problem
although you follow the instructions
in this section, consult your dealer
or the Authorised Service Agent.
Never try to repair a nonfunctional
product yourself.
Check the HomeWhiz section for
the relevant troubleshooting in-
formation.
EN / 44