Compaq TFT8030 User Manual page 7

After you turn on the monitor, install the Compaq LCD Display
Assistant utility included on the CD-ROM. Use the on-screen
instructions to adjust the picture quality of your monitor. To
install this utility, follow the instructions on the "Configuring
Your Compaq LCD Monitor" card located in the Program
License Agreement packet.
Important: Always activate a screen saver program, the
programmable sleep timer, the Compaq Display LiteSaver
utility, or turn off the monitor when it is not in use for a
prolonged period of time. All LCD monitors that display the
same static image on screen for a prolonged period of time may
exhibit screen image retention. Note that image retention is not a
permanent condition and will fade over a period of time. Image
retention is a condition that may occur on all LCD screens.
Connecting the Video Signal Cables
To connect the VGA analog or DVI-D (Digital Visual Interface-
Digital) cable to the corresponding connector on the back of the
monitor, you must first remove the monitor base cover.
WARNING: Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and signal cables are both
disconnected.
The DVI-D cable supplied with this monitor is for digital- to-
digital connection only. Your computer must have a DVI-
compatible graphics card installed for use with this cable. When
connecting the DVI-D signal cable to the DVI connector on the
monitor, you must connect the other end of the DVI-D cable to
the DVI connector on the computer.
TFT8030 User's Guide 5