Advertisement
Note:
Before using, please install the batteries (included) in the battery compartment of the device.
●
When there is no operation on the buttons for 10 seconds, the backlight of the device will
●
automatically turn off to enter Low Power Mode.
1) Power on/off
Press and hold the Power/Set Button for 3 seconds.
2) Connect the probe to the device
Plug the connection port of the probe jack to the device. The screen will display the current
temperature of the probe.
3) Switch the measurement unit
Remove the battery compartment cover on the device. Hold the Temperature Alarm Button for 3
seconds until it beeps to switch the temperature unit between Fahrenheit and Celsius ( the
default unit is Fahrenheit ).
4) Set the preset temperature
a) Press the Power/Set Button
b) Press the "+"/"-" Button to increase / decrease the value or hold the button to speed up the
adjusting.
c) Press the Power/Set Button
be automatically confirmed.
Note:
When the measured temperature reaches the preset temperature, the device will start beeping
and the value display will keep flashing. Press any button on the device to stop the flashing and
beeping.
Instructions of the Device
o
o
to enter the preset temperature setting.
o
to confirm the setting. Or wait for 10 seconds, the value will
06
Advertisement
